Unpacking the modules and storage. Autarco MD(E)-series, MB-series, MA-series
Add to My manuals9 Pages
Autarco MA-series is a line of solar PV modules designed to convert sunlight into electricity. These modules are made of high-quality materials and are built to last. They are also easy to install and maintain, making them a great choice for both residential and commercial applications.
Autarco MA-series modules are available in a variety of wattages and sizes, so you can choose the perfect module for your needs. They are also backed by a 25-year warranty, so you can be sure that they will provide years of reliable service.
Here are some of the benefits of using Autarco MA-series solar PV modules:
advertisement
2.2
Unpacking the modules and storage
The utmost care is required when handling the modules. Take care when unpacking, transporting, and storing them.
Leave modules in packaging until they are to be installed.
Carry modules with both hands.
Do not use the connection socket as a handle.
Do not stand modules on hard or rough ground.
Do not stand modules on their corners.
Ensure modules do not bend.
Do not subject to load over 5400N, do not stand on them, do not drop.
Do not mark or work on them with sharp objects.
Keep all electrical contacts clean and dry.
If it is necessary to store the modules temporarily, a dry, ventilated room should be used.
2.3
General instructions
Ensure that the module is used for its intended purpose only. Pay attention to the local ordinances, building standards and accident prevention regulations during installation. The safety information for other system components must also be followed.
3.
Installation
ATTENTION! Do not carry out installation work when there are strong winds. Secure yourself and other workers to avoid falling. Secure work materials to prevent articles from falling. Create a work zone to avoid accidents.
WARNING! The following paragraphs are very important. Failure to comply to these instructions can lead to system underperformance and will void the Autarco kWh guarantee.
3.1
Keeping within the maximum permitted load
Make sure the support structure adheres to maximum permissible load requirements as prescribed by local ordinances, particularly in regions of high snow accumulations and high wind velocities. Take notice to possible bending of the modules under high loads. If possible, avoid installing fasteners, cable ties, etc. between the module backside and support structure (i.e. on mounting rails) as any sharp edges can damage module.
3.2
Grounding
The company installing the PV module frame is also responsible for proper grounding. If the building is already equipped with an exterior lightning protection system, the PV-installation must be integrated in this protection system against direct effects of lightning. Country specific standards must be adhered to. A grounding method authorized by UL is mandatory in the US and Canada.
6 Solar PV Module
advertisement
Related manuals
advertisement
Table of contents
- 4 Introduction
- 4 Read this first
- 4 Target Audience
- 4 Product versions covered by this document
- 5 Preparation
- 5 Safety instructions
- 6 Unpacking the modules and storage
- 6 General instructions
- 6 Installation
- 6 Keeping within the maximum permitted load
- 6 Grounding
- 7 Fire safety
- 7 Suitable environmental conditions
- 7 Suitable installation
- 7 Optimum orientation and tilt
- 7 Shading
- 8 Mounting
- 9 Wiring
- 9 Cable protection
- 9 Maintenance
- 9 Disclaimer of liability