Mounting. Autarco MD(E)-series, MB-series, MA-series

4.

Mounting

Each module must be securely fastened at a minimum of four (4) points on two (2) opposite sides. The following clamping positions should be adhered to:

Clamping positions when clamping on the long sides

MA series

MB-series

MC(E)-series

MD(E)-series

PC(E)-series

PD(E)-series

220 – 340mm

220 – 340mm

220 – 340mm

340 – 550mm

220 – 340mm

340 – 550mm

Clamping positions when clamping

on the short sides

MA series 150 – 200mm

MB-series 200 – 250mm

MC(E)-series

MD(E)-series

PC(E)-series

PD(E)-series

200 – 250mm

200 – 250mm

200 – 250mm

200 – 250mm

PV modules can be mounted to a substructure by clamping at the front side of the module frame or by screwing at the back side of the frame.

8

 The tightening torque must be 8-10 Nm.

 Do not drill any additional holes into the module.

 Use appropriate corrosion-proof fastening materials.

WARNING! Product warranty may be void in cases where above clamping positions, improper clamps or unsuitable installation methods are found.

Solar PV Module