Manufacturer Declarations. Sennheiser Electronic Corp DMOHD4BT4

Add to My manuals
27 Pages

advertisement

Manufacturer Declarations. Sennheiser Electronic Corp DMOHD4BT4 | Manualzz

Manufacturer Declarations

Manufacturer Declarations

Warranty

Sennheiser Communications A/S gives a warranty of 24 months on this product. For the current warranty conditions, please visit our website at www.sennheiser.com or contact your Sennheiser partner.

Sennheiser product warranty FOR AUSTRALIA ONLY

In Sennheiser’s goods come with guarantees that cannot be excluded under the

Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.

You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

This warranty is in addition to other rights or remedies under law. Nothing in this warranty excludes, limits or modifies any liability of Sennheiser which is imposed by law, or limits or modifies any remedy available to the consumer which is granted by law.

To make a claim under this warranty, contact

Sennheiser Australia Pty Ltd,

Unit 3, 31 Gibbes Street Chatswood NSW 2067, AUSTRALIA

Phone: (02) 9910 6700, email: [email protected].

All expenses of claiming the warranty will be borne by the person making the claim. The Sennheiser International Warranty is provided by Sennheiser

Australia Pty Ltd (ABN 68 165 388 312), Unit 3, 31 Gibbes Street Chatswood

NSW 2067 Australia.

In compliance with the following requirements

• WEEE Directive (2012/19/EU)

Please dispose of this product by taking it to your local collection point or recycling center for such equipment. This will help to protect the environment in which we all live.

• Battery Directive (2013/56/EU)

The product‘s built-in rechargeable batteries can be recycled. In order to protect the environment, please dispose of defective products with built-in rechargeable batteries as special waste or return them to your specialist dealer.

CE Conformity

• R&TTE Directive (1999/5/EC)

• EMC Directive (2014/30/EU)

• Low Voltage Directive (2006/95/EC)

• ErP Directive (2009/125/EC)

• RoHS Directive (2011/65/EU)

The declaration is available on our website at www.sennheiser.com.

Before putting the product into operation, please observe the respective country specific regulations!

Trademarks

The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Sennheiser electronics GmbH & Co.

KG is under license.

iPhone® and iPod® are registered trademarks of Apple Inc, registered in the U.S. and other countries.

The aptX® mark and the aptX logo are trade marks of CSR plc or one of its group companies and may be registered in one or more jurisdictions.

22 | URBANITE XL Wireless - Bluetooth headset

Sennheiser Communications A/S

Industriparken 27, DK-2750, Denmark www.sennheiser.com

Publ. 08/ 14, A01

Federal Communication Commission Interference Statement

( NOTE : The text below is for all Wireless products / radio products )

FCC Declaration of Conformity

FCC Declaration of Conformity

Sennheiser

Model No: Urbanite &

Urbaqnite XL Wireless

We, Sennheiser Electronic Corporation

One Enterprise Drive · Old Lyme ·

CT 06371 · USA

Tel : +1(860)4349190 ext144

Fax :+1(860)434 1759 ext144 declare the above device complies with the reqirements of Federal Communication Commision.

This device complies with Part 15 of the FCC rules.operation is subjected to the following two conditions:

1)This device may not cause harmful interference,and

2) This device must accept any interference received, including interference that may cause undesired operation.

Responsible party ; Greg Beebe

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter

Radiation Exposure Statement:

Since the radiated output power of this device is far below the FCC radio frequency exposure limits, it is not subjected to routine RF exposure evaluation as per Section 2.1093 of the FCC rules.

Industry Canada statement:

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

………………………………………………………………

CAN ICES-3 (B) /NMB-3(B)

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Radiation Exposure Statement:

Since the radiated output power of this device is far below the Canada radio frequency exposure limits, it is not subjected to routine RF exposure evaluation as per RSS -102 Industry Canada

Déclaration d'exposition aux radiations:

The text below to be translated in French

Depuis la puissance de sortie rayonné de cet appareil est bien inférieure aux limites d'exposition aux fréquences radio au Canada , il n'est pas soumis à une évaluation de routine de l'exposition aux RF selon la RSS -102 Industrie Canada

CAN ICES-3 (B) /NMB-3(B)

Manufacturer Declarations

Sennheiser Communications A/S

Industriparken 27, DK-2750, Denmark www.sennheiser.com

Publ. 08/14, A01

URBANITE XL Wireless - Bluetooth headset | 23

advertisement

Related manuals