Removing the Front Bezel. Avid Technology Evo Workstation w8000, Rack-Mount Kit

8 Installation Instructions

Removing the Front Bezel

To remove the front bezel:

1. Release the two front bezel latches (see Figure 6).

2. Pull the front bezel off the front of the system from the latch side.

Latches

Front bezel

Figure 6 Removing the Front Bezel

Replacing the Diskette Drive

You must replace the existing diskette drive with the diskette drive in the rack-mount kit. The diskette drive in the rack-mount kit provides a longer eject button. The longer button needs to extend beyond the new front bezel.

Installing the Tower-to-Rack Conversion Kit Part 0130-05337-01 Rev. B

Installation Instructions

To remove the diskette drive:

1. Remove the two screws that secure the diskette drive (see

Figure 7).

2. Slide the diskette drive out slightly to gain access to the cables.

3. Disconnect the signal and power cables from the back of the diskette drive.

9

Drive cage

Screws

Diskette drive

Part 0130-05337-01 Rev. B

Figure 7 Installing the Rack-Mount Diskette Drive

4. Remove the diskette drive from the drive cage.

To install the rack-mount diskette drive:

1. Insert the new diskette drive that came with the rack-mount kit into the drive cage (see Figure 7).

2. Connect the signal and power cables on the back of the diskette drive.

Installing the Tower-to-Rack Conversion Kit