10 Installation Instructions
3. Secure the diskette drive with the screws removed from the original diskette drive.
c
Use only 5mm-long screws. Longer screws can damage the internal components of the diskette drive. Be sure cables are placed in their original locations during the reassembly process. Improper cable placement can damage the system.
Removing the Front I/O Assembly Module
To remove the front I/O assembly module:
1. Remove the four screws securing the front I/O assembly module to the chassis (see Figure 8).
Front I/O assembly module
Figure 8
Power-on ribbon cable
1 of 4 screws
Removing the Front I/O Assembly Module
Installing the Tower-to-Rack Conversion Kit Part 0130-05337-01 Rev. B
Installation Instructions 11
2. Pull the front I/O assembly slightly out from the chassis to gain access to the I/O board mounted inside the assemble module.
3. Disconnect the power-on ribbon cable from the I/O board.
4. Remove the front I/O assembly module from the chassis.
5. Disconnect the power-on ribbon cable from the system board.
n
Most Avid systems will have expansion boards and a fan assembly installed that might need to be removed to gain access to the power-on connector on the system board. For instructions on removing the fan assembly and information on your system’s expansion board slot configuration, see your Avid Product
Setup Guide.
6. Remove the power-on cable from the chassis.
Part 0130-05337-01 Rev. B Installing the Tower-to-Rack Conversion Kit
