Selecting the Operation Command
Chapter 5-4
5-4 Selecting the Operation Command
The following description provides information on how to input operation commands to start or stop the Inverter or change the direction of rotation of the Inverter.
Three types of command input methods are available. Select either one of them according to the application.
Selecting the Operation Mode (n02)
• Select the method of operation mode input to start or stop the Inverter.
• The following method is enabled in remote mode only. The command can be input through key sequences on the Digital Operator.
n02 Operation Command Selection No
Setting range
0 to 2 Unit of setting
1
Changes during operation
Default setting 0
0
1
2
Set Values
Value Description
The RUN and STOP/RESET Keys of the Digital Operator are enabled.
Multi-function input in 2- or 3-wire sequence through the control circuit terminals is enabled.
Operation commands via RS-422A/485 communications are enabled.
Selecting the STOP/RESET Key Function (n06)
• When parameter n02 is set to 1, set whether or not to use the STOP/
RESET Key of the Digital Operator to stop the Inverter in remote mode.
The STOP/RESET Key is always enabled in local mode regardless of the setting in n02.
n06 STOP Key Function Selection No
Setting range
0, 1 Unit of setting
1
Changes during operation
Default setting 0
Set Values
0
1
Value Description
The STOP/RESET Key of the Digital Operator is enabled.
The STOP/RESET Key of the Digital Operator is disabled. This setting is available only when the Digital
Operator is selected for operation command input.
54
