Motor System. KitchenAid Commercial Style Wall-Mount Canopy Range Hood

Make Electrical Connections for In-Line Blower Motor System

WARNING WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Electrical Connection Inside In-line Blower System

1. Disconnect power.

2. Connect the wires from the wiring conduit to the wires from the motor electrical plug cable inside the in-line blower housing terminal box.

B

A

C

D

E

F

G

H

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire in terminal box.

Failure to do so can result in death or electrical shock.

8. Connect the green (or yellow/green) ground wire to the green/yellow ground wire (H) in the terminal box using UL listed wire connectors.

9. Reinstall the in-line blower terminal box cover and screw.

10. Reinstall the front cover of the in-line blower housing and secure it with 10 mounting screws.

Electrical Connection Inside Range Hood Between In-line

Blower System and Range Hood

1. With the range hood mounted (see the “Install Range Hood” section), locate the wiring cable connector inside the range hood.

2. Connect the 6-wire connector assembly supplied with the in-line blower motor system to the mating cable connector from the range hood.

A. UL listed or CSA approved

¹⁄₂

" (1.3 cm) wiring conduit

B. UL listed wire connectors

C. Black wires

D. White wires

E. Red wires

I

F. Blue wires

G. Gray wires

H. Green (or yellow/green) and green/yellow wires

I. Motor electrical plug cable

3. Use UL listed wire connectors and connect the black wires

(C) together.

4. Use UL listed wire connectors and connect the white wires

(D) together.

5. Use UL listed wire connectors and connect the red wires (E) together.

6. Use UL listed wire connectors and connect the blue wires (F) together.

7. Use UL listed wire connectors and connect the gray wires (G) together.

3. Locate the terminal box inside the range hood and install a

¹⁄₂ " (1.3 cm) UL listed or CSA approved strain relief (see

“Complete Preparation” in the “Prepare Location” section).

4. Run the wire ends from the 6-wire connector assembly through the ¹⁄₂ " (1.3 cm) strain relief, leaving enough wire length to make the wiring connections. Tighten the strain relief screws.

5. Connect the wires from the 6-wire connector assembly to the wires from the wiring conduit inside the range hood terminal box.

12