RANGE HOOD CARE. KitchenAid Commercial Style Wall-Mount Canopy Range Hood

RANGE HOOD CARE

Range Hood Lamps

Replacing a LED Lamp

Turn off the range hood and allow the LED lamp to cool. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. Replace bulb, using tissue or wearing cotton gloves to handle bulb.

If new lamps do not operate, make sure the lamps are inserted correctly before calling service.

1.

Disconnect power.

2.

Push up on the lens and turn it counterclockwise.

Cleaning

IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood.

Exterior surfaces:

To avoid damage to the exterior surface,do not use steel wool or soap-filled scouring pads. Rub in direction of the grain line to avoid scratching the surface.

Always wipe dry to avoid water marks.

Stainless Steel Cleaner and Polish.

Mild liquid detergent and water.

Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry.

Metal Filters and Drip Trays:

Use 2 hands to remove filters. Grasp filter handles, pull toward the front of range hood and pull down on the rear handle to remove. Repeat for each filter.

A

3.

Remove the bulb and replace it with a 120-volt, 6.5 watt maximum LED bulb with a GU10 base. Turn it clockwise to lock it into place.

4.

Repeat steps 2-3 for the other bulbs if needed.

5.

Reconnect power.

Remove grease drip tray.

A. Grease filter

A

A. Drip tray

Wash metal filters and grease trays as needed in dishwasher or hot detergent solution to clean.

Replace grease drip tray.

Reinstall filters, grasp filter handles and place front edge of filter into the hood. Push up on the back handle and set rear of filter into the drip tray to secure. Repeat for each filter.

A

A.Grease filter

15