5.3 Wall-mount Plate Mounting. Planet IPOE-162

Step 2: Reverse the mounting steps to remove the device from the track.

5.3 Wall-mount Plate Mounting

To install the industrial device on the wall, please follow the instructions described below:

Step 1: Remove the DIN-rail bracket from the industrial device by using a screwdriver.

Step 2: Then screw the wall-mount plate on the rear panel of the industrial device.

Figure 5-4: Placing Wall-mount Plate on Industrial Device

Step 3: Use the holes in the corners of the wall-mount plate to hang the industrial device on the wall.

Step 4: To remove the wall mount plate, reverse steps above.

15