7) Engine Stop Switch. Can-Am Outlander 400 EFI

CONTROLS/INSTRUMENTS/EQUIPMENT

Button used to start the engine.

Press and hold to start engine. Release immediately after engine is started.

Refer to the

STARTING THE ENGINE

OPERATING INSTRUCTIONS

in section for complete procedure on how to start the engine.

vmo2010-011-001_b

HEADLIGHT SWITCH

1. Headlight switch

2. Low beam and taillight

3. High beam and taillight

7) Engine Stop Switch

The engine stop switch is located on the LH side of the handlebar.

This switch can be used to stop engine and as an emergency control.

To stop engine, fully release throttle lever then use the engine stop switch.

All operators of this vehicle should familiarize themselves with the function of this device by using it several times on first outing and whenever stopping the engine thereafter. This engine cut-out procedure will become a reflex and will prepare operators for emergency situations requiring its use.

vmo2010-011-001_d

1. Engine start button

9) Override Button

The override button is located on the

LH side of the handlebar.

This button is used to override the reverse speed limiter system while power backing up.

Press and hold the override button then depress throttle lever gradually.

WARNING

Never activate the override button if throttle lever is already depressed as a loss of control may result, causing severe personal injury or death.

vmo2010-011-001_c

1. Engine stop switch

8) Engine Start Button

The engine start button is located on the LH side of the handlebar.

_______________

75