24) Winch Control Switch. Can-Am Outlander 400 EFI

CONTROLS/INSTRUMENTS/EQUIPMENT

24) Winch Control Switch

XT Models

Use this switch to roll in or out wire from winch.

To let out the cable, press the left side of switch.

To reel out the cable, press the right side of switch.

Refer to

BASIC GUIDE TO WINCHING

TECHNIQUES

for proper operating instructions.

vmo2009-015-200_a

26) Turn Signal Switch

The turn signal switch is located on the

LH side of handlebar.

vmo2010-011-001_e

1. Roll in

2. Roll out

25) Vehicle Lock

The vehicle lock is located next to the park position of the shifter, on the right hand side of the vehicle.

His purpose is to lock the transmission shifter lever in park position.

NOTE: The vehicle will not be lock if the transmission shifter in not placed in park position when the mecanism is engaged.

vmo2010-011-001_f

1. Turn signal switch

To activate the turn signals, push the switch button on the right or left side, depending which direction you picked.

Reposition the switch in the middle when the maneuver is completed.

27) Horn Button

The horn button is located on the LH side of handlebar.

88

______________