advertisement
lmo2001-005a.book Page 33 Wednesday, February 28, 2001 4:20 PM
PRE-OPERATION CHECKS
WARNING
The pre-operation check is very important prior to operating the craft. Always check the proper operation of critical controls, safety features and mechanical components, before starting as listed hereinafter. If not done as specified here, severe injury or death might occur. Bring all safety equipment required by local laws.
Some of the following items may not have been previously covered in this guide, however they will be described in the MAINTENANCE or SPECIAL PROCE-
DURES section. Please refer to these sections to have more detailed information.
WARNING
Engine should be off and the safety lanyard should always be removed from its post prior to verifying any of the following points. Only start craft once all items have been checked and operate properly.
ITEM
Hull
Jet pump water intake
Bilge
Battery
Fuel tank and oil reservoir
Engine compartment
Fire extinguisher
Inspect.
OPERATION
Inspect/clean.
Drain. Ensure plugs are secured.
Inspect tightness of cables and retaining straps.
Refill.
Verify for any fuel leak/odor.
Inspect condition/mounting.
Steering and throttle systems
Shifter system
Check operation.
Check operation.
Inflatable tube
Storage compartment covers and seat
Safety lanyard, engine start/stop button
Visually inspect/verify air pressure.
Ensure they are closed and latched.
Check operation.
✔
NOTE: See the detailed instructions hereinafter.
33
lmo2001-005a.book Page 34 Wednesday, February 28, 2001 4:20 PM
Hull
Inspect hull for cracks or damage.
Jet Pump Water Intake
Remove weeds, shells, debris or anything else that could restrict the flow of water and damage cooling system or propulsion unit. Clean as necessary.
If any obstruction can not be removed, refer to an authorized SEA-DOO dealer for servicing.
1
F03J01Y
TYPICAL
1. Inspect this area
Inspect leading edges of the impeller, if they have nicks or bends, performance will be greatly reduced.
Bilge
Should water be found in the bilge, it can be easily drained by unscrewing the drain plugs when engine is off and craft is out of water.
Tilt the craft slightly to the rear so that the water can completely flow out of the bilge.
It is suggested to drain bilge on a ramp.
Reinstall bilge drain plugs.
WARNING
Make sure drain plugs are properly secured prior to launching the craft in water.
Battery
WARNING
Verify tightness of battery cables to their posts and condition of battery retaining straps/fasteners. Do not boost battery while installed.
Fuel Tank and Oil
Reservoir
With the craft horizontal, fill the fuel tank to specified level with fuel.
Check the oil level and refill reservoir as necessary.
Check fuel tank and oil reservoir retaining straps/fasteners.
Engine Compartment
WARNING
Should any leak or gasoline odors be present, do not start the engine.
Refer to an authorized SEA-DOO dealer before use.
Fire Extinguisher
Make sure it is full, in good condition and well secured.
Steering and Throttle
Systems
Assisted by another person, check steering operation for free movement.
When the handlebar is horizontal, the jet pump nozzle should be in the straight ahead position. Ensure the jet pump nozzle pivots easily while handlebar is turned.
WARNING
Check handlebar and corresponding steering nozzle operation before starting.
34
lmo2001-005a.book Page 35 Wednesday, February 28, 2001 4:20 PM
Check throttle lever for free and smooth operation. It should return to its initial position immediately after it is released.
WARNING
Check throttle lever operation before starting the engine.
CAUTION: Engine can be flooded if throttle lever is applied several times when engine is not running. If engine is flooded, it will not start.
Shifter System
Check reverse gate operation for free movement. With the shift lever pushed in and locked, the gate should be in upward position. Ensure the reverse gate moves easily while shift lever is pulled out.
WARNING
Verify the reverse gate operation before starting the engine.
Inflatable Tube
Inspect tube for scratches and/or damage. Verify air pressure using valve adapter and pressure gauge. The air pressure should always be at 21 kPa (3 PSI).
NOTE: The valve adapter is part of the tube repair kit. A low pressure gauge can be used.
CAUTION: An incorrect pressure will reduce the tube service life.
WARNING
Never inflate tube more than 21 kPa
(3 PSI). Inflating tube more than specified pressure may damage tube and cause personal injury. Never use high pressure to inflate tube.
Storage Compartment
Covers and Seat
Ensure they are closed and latched.
WARNING
Make sure seat is securely latched.
WARNING
Never leave any heavy or breakable objects loose in the storage compartment. Never operate the craft with the storage compartment cover open.
Safety Lanyard and Engine
Start/Stop Button
Ensure that both switches operate properly. Start engine and stop it using each switch individually.
WARNING
Should the safety lanyard cap be loose or fail to remain on its post, replace it immediately in order to avoid unauthorized use or theft.
WARNING
If engine does not shut-off when pushing engine start/stop button or by disconnecting the safety lanyard, stop the engine by applying the choke and turning fuel valve to
OFF position. Do not operate the craft further, see an authorized
SEA-DOO dealer.
35
advertisement