FUNCTIONS OF CONTROLS, COMPONENTS AND INSTRUMENTS. Sea-doo XP DI

8

FUNCTIONS OF CONTROLS, COMPONENTS AND

INSTRUMENTS

The following components have the same operation as explained in the 2003 Operator’s

Guide, only their location differ. To know where they are located, refer to the LOCA-

TION OF CONTROLS, COMPONENTS AND

INSTRUMENTS section in the previous pages.

14) Fuel Tank Cap

18) Tool Kit

19) Air Intake Opening

23) Rear Grab Handle

The following components are specific to the

XP DI models

. Refer to the following updated texts and/or illustrations.

15) Oil Injection Reservoir Cap

Open engine cover and remove storage tray.

F08G04Y

Reinstall cap and fully tighten it.

MAXIMUM

OIL LEVEL

MAXIMUM

OIL LEVEL



WARNING

Do not overfill. Never exceed the MAX.

oil level line. Reinstall cap and fully tighten. Oil is inflammable. Always wipe off any oil spillage from the bilge.

1

16) Front Storage Compartment

Cover

It gives access to the front storage compartment. Always relatch cover after closing.

The tray is provided with separate compartments.

1

2

F08L0VZ

TYPICAL

1. Oil injection reservoir cap

To add injection oil in the reservoir, unscrew the cap counterclockwise.

Do not overfill. Make sure oil level does not exceed the level shown on the following drawing. Otherwise, siphon out the extra oil.

Do not operate the engine when oil level exceeds the recommendation.

F08L0UY

1. Fire extinguisher (sold separately)

2. Retaining strap



WARNING

Ensure to properly secure extinguisher with the supplied retaining straps.

26) Mooring Cleats

All Models

These cleats can be temporarily used for docking, while refueling for example.

CAUTION:

Never use mooring cleats to pull or lift the watercraft.

42) Rear Access Cover

It gives access to the battery, drive system, suspension, exhaust system and bailer pickups. Always relatch cover.

43) Automatic Bilge Pump

Bilge pump evacuates water from the bilge.

When safety lanyard cap is installed on its post, bilge pump automatically turns on. It will remain on until all water is evacuated, if any, then it will shut down automatically.

When engine is running, bilge pump will automatically start periodically to evacuate water.

F08L0TZ

1. Mooring cleats

1

37) Fuses

Fuses are located in engine compartment.

Refer to MAINTENANCE for more details.

38) Battery

Battery is located in bilge under seat. Refer to

SPECIAL PROCEDURES.

41) Storage Compartment/

Engine Cover Latches

Pull both latch levers upward in order to open the storage compartment/engine cover. Always relatch cover on both sides.

NOTE:

Verify periodically the lock pins tightness. Tighten if needed and make sure storage compartment/engine cover latches properly.

9