MAINTENANCE. Sea-doo XP DI

MAINTENANCE

Lubrication

Seal Carrier

Using a grease gun, carefully lubricate seal carrier of mid bearing until grease is just coming out of seal.

F08E0BY

1. Grease seal carrier of mid bearing

Periodic Inspection Chart

The following is to be added for the

XP DI models.

DESCRIPTION

I

: Inspect, verify, clean, adjust, lubricate, replace if necessary

C

: Clean

L

: Lubricate

R

: Replace

FREQUENCY

1

PTO flywheel and seal carrier L L

13

Fuses

Refer to this updated text and illustrations.

Fuses can be found at 2 locations; on the

MPEM and in the electrical box.

MPEM

To access fuses on the MPEM, open front storage compartment cover and remove storage tray.

Locate MPEM on the left side of watercraft.

1

2

F1 : FP 15A

F2 : ACC 2A

F3 : REG 25A

F4 : VTS 7.5A

F5 : BAT 25A

F6 : INJ 15A

1

F1 F2 F3 F4 F5 F6

F08H0JY

1. MPEM

Fuses are identified, look above and besides the fuse holder.

F18H06Y

FUSE IDENTIFICATION

1. Fuse identification

2. Fuse description

Fuse identification:

The fuses (F) are identified from 1 to 6.

Fuse description:

The fuses are described with abbreviation as follows:

FP:

Fuel pump

ACC:

Accessories (information center)

REG: Regulator (charging system)

VTS:

Variable Trim System

BAT:

Battery

INJ:

Injection system

The fuse description is followed by the ampere rating (A).

Reinstall storage tray and properly relatch storage compartment cover.

Electrical Box

To access fuses in the electrical box, open front storage compartment cover.

Locate electrical box on the right side of watercraft.

14

1

Electric bilge pump fuse is located at the bottom of the electrical box.

F08H0KY

1. Electrical box

Unclip and remove cover of the electrical box to expose the holder of the main fuse.

1

F12H02Y

1

1. Electric bilge pump fuse

Properly reinstall removed components.

Properly relatch storage compartment cover.

1°

F18H1BY

TYPICAL

1. Fuse holder

2°

15