6.2 Rear Panel. CYP CDPS-CS6

6.2 Rear Panel

POWER

DC 5V CONTROL

(POE)

RS485

RS422

RS232

SERVICE

RX+ RXTD-

RXD

TD+ GND

TD+

TD-

GND

TXD GND

5 4 3 2 1

COMPORT

5V

GND 5

1 2 3 4

6 7 8

TRIGGER IN IR IN

1 2 3 4 5 6

4

1 DC 5V: Plug the 5V DC power supply into the unit and connect the adaptor to an AC outlet.

2 CONTROL (POE): Connect with PC/Laptop or intra-net hub for

Telnet/WebGUI control over the devices. If the connected Hub supports PoE function this device may not need to connect with power supply.

3 USB: This slot is reserved for factory firmware update only.

4 COMPORT: These slots are to connect with comport control devices such as RS-232/422/485 with RS baud rate up to 115200.

5 TRIGGER IN: Connect with event device’s signal 5V lines such as window security alarm, door switch, and etc… for trigger signal sending back to Control System.

6 IR IN: Connect with IR Receiver included in the package for IR signal receiving and learning. Send the IR signal that is to be learned by press on the remote control in direct line-of-sight towards the Receiver and use the software to record the IR data into digital format. For software details please refers to section 6.5.

6.3 IR Pin Definition

IR Blaster

1

2

3

Power

IR Blaster Signal

NC

IR Extender

IR Signal

Power

Grounding

IR Learner

1

2

3

IR Signal

Power

Grounding

Note: Due to both IR Extender and IR Learner cables are with similar outlook, a part no. "CBL-IR10C3SA200A sticker has been placed to differentiate the difference on IR Learner.

5