MAINTENANCE CHART

I

GB

Please note that the following maintenance intervals apply for normal operating conditions only. If your daily work requires longer than normal or harsh cutting conditions are present the suggested intervals should be shortened accordingly.

F

D

E

SK

P

GR

TR

CZ

Complete Machine

Controls (on/off switch, safety button)

Chain Brake

Oil Tank

Chain Lubrication

Saw Chain

Guide Bar

Inspect (Leaks, Cracks, and Wear)

Check Operation

Check Operation

Check by Dealer

Inspect (Leaks, Cracks, and Wear)

Check operation

Inspect (Damage, Sharpness, and Wear)

Check Tension

Sharpen (Check Gauge Depth)

Inspect (Damage, and Wear)

Clean Bar groove and Oil Passages

Rotate, Lubricate Sprocket Nose and

Deburr

Replace

Inspect (Damage, and Wear) Rim Sprocket

Replace

All Accessible Screws and Nuts Inspect - Retighten

Motor crankcase louvers

Power cable

Clean

Inspect (Damage, and Wear)

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

X

PL

9. STORAGE

If the machine is to be stored for long periods:

- Make see that the electrical plug is disconnected from the mains.

- Follow all the maintenance regulations described above.

- Completely empty the tank of chain

32 lubricant and close the cap

- Run the machine empty to completely empty also the delivery pipe and the oil pump.

- Clean the saw thoroughly.

- Put the blade-cover on. Store the saw in a dry place, preferably off the ground, and away from heat sources.