About the Book
At a Glance
Document Scope
This manual describes setting up the Momentum communicator on Fipio.
Validity Note
The data and illustrations found in this book are not binding. We reserve the right to modify our products in line with our policy of continuous product development. The information in this document is subject to change without notice and should not be construed as a commitment by Schneider Electric.
Related Documents
Title of Documentation
Modicon Momentum I/O Base User Guide
Modicon Momentum 170 AEC 920 00 User Manual
Reference Number
870 USE 002
870 USE 008
You can download these technical publications and other technical information from our website at www.schneider-electric.com.
W915905430301A 10/2008
7
Product Related Information
Schneider Electric assumes no responsibility for any errors that may appear in this document. If you have any suggestions for improvements or amendments or have found errors in this publication, please notify us.
No part of this document may be reproduced in any form or by any means, electronic or mechanical, including photocopying, without express written permission of
Schneider Electric.
All pertinent state, regional, and local safety regulations must be observed when installing and using this product. For reasons of safety and to ensure compliance with documented system data, only the manufacturer should perform repairs to components.
When controllers are used for applications with technical safety requirements, please follow the relevant instructions.
Failure to use Schneider Electric software or approved software with our hardware products may result in improper operating results.
Failure to observe this product related warning can result in injury or equipment damage.
User Comments
We welcome your comments about this document. You can reach us by e-mail at [email protected].
8
W915905430301A 10/2008
