Accessories. Sennheiser EK 2000 IEM

Accessories

Problem Possible cause Possible solution

Audio signal has a high level of background noise

Transmitter sensitivity is adjusted too low

Adjust the transmitter sensitivity correctly

(see the instruction manual of the transmitter).

Audio signal is distorted

No access to a certain channel

Transmitter sensitivity is adjusted too high

Adjust the transmitter sensitivity correctly

(see the instruction manual of the transmitter).

During scanning, an RF signal has been detected on this channel and the channel has been locked

Set the transmitter operating on this channel to a different channel and redo the frequency preset scan

(see page 21).

During scanning, a transmitter of your system operating on this channel has not been switched off

Switch the transmitter off and redo the frequency preset scan (see page 21).

If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local

Sennheiser partner for assistance.

To find a Sennheiser partner in your country, search at www.sennheiser.com under “Service & Support”.

Accessories

The following EK 2000 IEM accessories are available from your specialist dealer:

Cat. No.

009950

Accessory

BA 2015 accupack

009828

500432

L 2015 charger

IE 4 earphones

33