Installation. AEG 2003 f, 2003F-EWEURO

36

Installing and Connecting

INSTALLING AND CONNECTING

1

Important: Assembly and connection of the new appliance may only be performed by an approved installer.

Please observe this instruction, otherwise the warranty will not cover any damage that may occur.

Installation

Important Information

• The veneer or plastic coverings on kitchen furniture around the appliance must be bonded with heat resistant adhesive (100 °C). If plastic coverings or the adhesive are not sufficiently temperature resistant, then the covering may distort or come loose.

• In respect of fire protection, this appliance corresponds to type Y

(EN 60335-2-6). Only this type of appliance may built into positions with a high cupboard or wall on one side.

• The separation between the hob and the extractor hood must be at least as large as that given in the extractor hood installation instructions.

Appliance Alignment

Underneath the appliance there are 4 adjustable feet with the aid of which you can compensate for small amounts of unevenness in the floor.

0 1. Remove the utensils drawer

2. Turn the adjustable feet to raise or lower them until the cooker is level.

3. Replace the utensils drawer.

3

The adjustable feet are easier to turn if the cooker is tilted slightly to take the load off the feet.

_

+

_

+