To cancel the residual moisture evaporation process. Miele H 5961 B

Moisture plus

To cancel the residual moisture evaporation process

After the appliance has been

switched on, the prompt to evaporate residual moisture will appear in the display. Touch the sensor next to

"Cancel". You will only be able to run functions and Automatic programmes without Moisture plus.

If you select "Moisture plus" or one of the Automatic programmes with

Moisture plus, the prompt to evaporate residual moisture will appear immediately.

If you do not want to start the residual moisture evaporation process, you will need to press the Cancel sensor for at least 3 seconds.

You can now start the cooking programme.

,

Do not cancel the prompt for residual moisture evaporation too often, as this might cause the steam injection system to overflow when taking in more water.

Descaling

The oven will need to be descaled depending on the number of cooking programmes using Moisture plus which have been run and the amount of water taken into the oven for these. This will be indicated in the display.

The steam injection system should be descaled regularly. How often this needs to be done will depend on the water hardness level in your area.

You can start the descaling process at any time by selecting "Descale" in the main menu.

If you do not carry out the descaling process when the prompt to descale the oven appears, you will only be able to run functions and Automatic programmes without Moisture plus.

See "Cleaning and care" for more information about descaling.

44

Minute minder (egg timer)

N

The minute minder can be used to time any activity in the kitchen, e.g. boiling eggs.

You can enter a time of up to a maximum of 9 hours, 59 minutes and

59 seconds.

You can set the minute minder at the same time as another timed programme, e.g. as a reminder to stir a dish or add seasoning etc.

With "Moisture plus d", it is a good idea to use the minute minder to remind you when to release the bursts of steam manually.

To set the minute minder

^ Touch the N sensor.

"0 : 00 : 00" will appear in the display.

^ Enter the minute minder time using the

+ or

sensors: first enter the hours, then the minutes and finally the seconds.

Confirm each hour/minute/second entry by touching the OK sensor.

The time counts down in the display.

At the end of the time set for the minute minder

– the

N symbol will flash.

– a tone will sound (provided this is activated - see "Settings - Volume -

Buzzer tones").

– the display will show the time counting upwards.

^ Touch the N sensor.

To alter the time set for the minute minder:

^ Touch the N sensor.

^ Use the U sensor to set the time to

"0 : 00 : 00" and then enter a new minute minder time.

^ Confirm your entry with the OK sensor.

To cancel the time set for the minute minder

^ Touch the N sensor twice.

45