- Computers & electronics
- TVs & monitors
- Flat panel accessories
- Peerless Industries
- RTONES
- User manual
Installation to Double Wood Stud Wall. Peerless Industries ONE-TP-S, ONE-TP, RTONES, RTONE
Add to My manuals
33 Pages
advertisement
Installation to Double Wood Stud Wall
WARNING
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.
NOTE: If mounting equipment weighing greater than 200 lbs, triple stud mounting is strongly recommended.
Skip to page 9
Wall plate (AA) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the studs.
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each stud’s center. Place wall plate on wall as a template. The top mounting slots should be 2.5" above the desired screen center as shown in figure 4.1. Level plate, and mark the center of the four mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill four 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using four #14 x 2.5" wood screws (DD) as shown in figure 4.2.
NOTE: Wall plate may be mounted up to 4" (102 mm) off center as shown in figure 4.1.
Skip to step 5.
4"
(102 mm)
AA
STUD
4"
(102 mm)
2.5"
(64 mm)
CS
CS = center of screen
fig. 4.1
DD
8 of 33
AA
fig. 4.2
ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
advertisement
Related manuals
advertisement
Table of contents
- 3 Parts List
- 4 Adjusting Tilt Brackets
- 5 Attaching Tilt Brackets to Screen using Baffled Fastener Pack
- 8 Installation to Double Wood Stud Wall
- 9 Installation to Triple Wood Stud Wall
- 10 Installation to Solid Concrete or Cinder Block
- 11 Mounting and Removal of Flat Panel Screen
- 26 ISSUED: 09-20-06 SHEET
- 14 Lista de piezas
- 15 Soportes inclinables ajustables
- 16 identificados y clasificados en las divisiones del empaque plástico
- 19 Instalación en una pared con montantes de madera dobles
- 20 Instalación en una pared con montantes de madera triples
- 21 Instalación en una pared de concreto macizo o de bloques de hormigón de escorias
- 22 Instalación y desinstalación de la pantalla plana
- 26 ISSUED: 09-20-06 SHEET
- 16 Para el Servicio al cliente llame al 1-800-729-0307 ó