System status table for version Unicode. EUCHNER CES-A-BMB, CKS, CES-FD-AP M-01-…, CES-FD-AP U-01-…, CES-A-LMN SC

Operating Instructions Field Evaluation Unit CES-FD-AP-.-01-…

System status table for version Unicode

LED indicator output

Operating mode State

Teach-in standby

Setup

Fault display

closed on

Normal operation

closed on open off open off closed

X

X off off off closed off

X

X off off

3 x

4 x

5 x flashes quickly

2 Hz

1 x

3 x

1 Hz

Normal operation, door closed

Normal operation, door closed, actuator in the boundary area

¨

Re-adjust door

Normal operation, door open, no actuator taught

Door open, unit is ready for teach-in for another actuator (only short time after power-up)

Teach-in operation

Positive acknowledgment after completion of teach-in operation

Fault on the power supply (e.g. Switch-off pulse duration of clocked power supply too long)

Defective actuator (e.g. fault in code or code not readable)

Output error (e.g. short circuits, loss of switching ability)

Internal fault (e.g. component faulty, data error)

Key to symbols

Important:

10 Hz (8 s)

X

3 x

LED not illuminated

LED illuminated

LED flashes for 8 seconds at 10 Hz

LED flashes three times, and this is then repeated

Any state

After the cause has been remedied, faults can generally be reset by opening and closing the door. If the fault is still displayed afterward, briefly interrupt the power supply. Please contact the manufacturer if the fault could not be reset after restarting.

If you do not find the displayed device status in the System status table, this indicates an internal device fault. In this case, you should contact the manufacturer.

18