advertisement
Service and Upgrade Procedures
iTrack Reader Installation and Replacement
iTrack Reader Installation and Replacement
The iTrack reader can either be supplied with a new unit or retrofitted to existing oness. See below for a wiring diagram:
Existing iTrack Reader
If the iTrack reader has been set up at the factory, it will connect to the prewired sockets on the DIN rail as follows:
Isolate the unit before attempting any work on the iTrack reader.
Compac Industries Ltd.
Page 109 www.compac.co.nz
iTrack Reader Installation and Replacement
Service and Upgrade Procedures
New Installation
Terminal
Tx
Wires
Red
iTrack Reader Wires
Orange and White
Rx
12V
Black
White
Orange
Blue and White
G Blue, Green and Shield Blue
To connect an iTrack reader where no DIN rail connection is supplied you can wire the reader to an RS232 plug as follows:
Compac Industries Ltd.
The picture above shows the factory wiring. When wiring the
iTrack direct to the RS232 plug use the colours in the table.
Page 110 www.compac.co.nz
Service and Upgrade Procedures
iTrack Reader Installation and Replacement
Wire Pin
Orange / White 2
Orange
Blue
3
5
Plug the RS232 plug into the supplied socket (generally labelled "Host") and plug the ribbon cable at the back of this socket into Port 3 on the Com
FMS board.
Connect the Blue/White wire to the 12v supply side of socket J17 on the
C4000 board and the blue wire to the earth (twinned with the wire to RS252 pin 5).
Compac Industries Ltd.
Page 111 www.compac.co.nz
advertisement
Related manuals
advertisement