Linear DC Analog Output Jumper Selection. RED LION CONTROLS P48, T48

LINEAR DC ANALOG OUTPUT JUMPER SELECTION

(Main & Second)

The Linear Analog DC Output ranges are selectable for either voltage

(0-10 V) or current (0/4-20 mA). The main set of jumpers must correspond with the configuration in Linear Output Range (ANAS) in the Output

Parameter Module (2-OP). The optional secondary set of jumpers must correspond with the configuration in Second Linear DC Output Range (A2tP) in the Second Linear DC Analog Output Module (8-A2). The jumpers are accessible from the rear after removing the controller from the case. Dashed lines show factory setting of 20 mA.

Figure 11, Linear Output Range Jumpers

-12-