Configure Module 1 - Input Parameters (1-IN) P48
These tables are only used for programming the P48 models. Use the tables on page 21 if you are programming a T48.
Display
tYPE dCPt rnd
FLtr
Parameter
Input Type
Decimal Point
Rounding
Increment
Digital Input
Filtering And
Display Update
Range and Units
(Factory Setting)
VOLt - Voltage
Curr - Current
(Curr)
0, 0.0, 0.00, or 0.000
(0.0)
1, 2, 5, 10, 20, 50, or
100
(0.1)
0 to 4
(1) dSP1
InP1 dSP2
Scaling Point #1
Display Value
Scaling Point #1
Input Signal
0/4-20 mA DC
0-10 VDC
-999 to 9999
(0.0)
0.00 to 20.00 mA
0.00 to 10.00 V
(4.00)
Value Key-in
Method
Signal Input
Method
Scaling Point #2
Display Value
-999 to 9999
(100.0)
Key-in input low value.
Apply input low value.
Key-in display high value.
Description/
Comments
If 0.000 is selected, scaling points must be a positive value.
Used in conjunction with filtering to stabilize the display reading.
Increase number for more filtering effect.
4 = 500 msec display update rate. Adjusted by Auto-Tune.
Key-in display low value.
Press D button to select Signal Input method.
Display
InP2
SPLO
SPHI
SPrP
InPt
Parameter
Scaling Point #2
Input Signal
0/4-20 mA DC
0-10 VDC
Range and Units
(Factory Setting)
0.00 to 20.00 mA
0.00 to 10.00 V
(20.00)
Value Key-in
Method
Signal Input
Method
Setpoint Lower
Limit
Setpoint Upper
Limit
Setpoint Ramp
Rate
User Input *
-999 to 9999
(0.0)
-999 to 9999
(999.9)
0 to 9999 units/minute
(0.0)
PLOC - Program disable
ILOC - Integral action on/off trnF - auto/manual select
SPrP - Setpoint ramp on/off
ALrS - Reset alarm output(s)
SP2 - Select SP1/SP2 rSP - Select
Local/Remote
PrNt - Serial block print
(PLOC)
Description/
Comments
Press D button to select Signal
Input method.
Key-in input low value.
Apply input low value.
Set low limit below high limit.
Set high limit above low limit.
0.0 is off (no ramping).
Low = lock
Low = off
Low = manual
Low = end ramp
Low = reset
Low = SP2
Low =remote
Low =block print
* Model Number Dependent
-22-
