TV channel setup
Automatic TV channel search
When the automatic channel search function is activated, the TV channels are searched and stored in a specific order. If the channel assignments of your TV content provider changes or if you are reinstalling the DVD-Recorder, you may need to start this procedure again.This will replace the stored TV channel with the new ones.
1.Ensure the antennas are securely connected to the DVD-Recorder.
2.Switch on the TV set and the DVD-Recorder.
3.Press [SETUP] to bring up the “SETUP” menu, press [
p] [q] to select the “TV TUNER” and
press [
u].
4.Press [
p] [q] to select “Utilities” and press
[
u].
5.Press [
p] [q] to select “START SCAN” and
press [ENTER] to start auto channel search.
4.Press [
t] [u][p] [q] to select the channel(s)
that you want to add or delete and press
[ENTER] to confirm it.
Move the cursor to the TV channel and you can press [ENTER] again to cancel delete operation.
5.Press [
t] [u][p] [q] to select “EXIT” and
press [ENTER] to save setting and exit the add/ delete menu.
Fine-tuning TV channel manually
After you have performed the automatic channel search you may like to fine tune the TV channel signal manually. Follow the steps below to complete fine tune.
1.Press [SETUP] to bring up the “SETUP” menu, press [
p] [q] to select the “TV TUNER” and
press [
u].
2.Press [
p][q] to select “FINE” and press [u].
3.Press [
p][q] to fine tune the channel signal.
6.The auto TV channel search starts. The procedure may take few minutes.
7.When all the TV channel have been searched and stored, press [SETUP] to exit.
Adding or deleting TV channel manually
After you have performed the automatic channel search, you may like to add or delete some of the TV channels. This function allows adding or deleting channel manually.
1.Press [SETUP] to display the “SETUP” menu, press [
p] [q] to select “TV TUNER” and press
[
u].
2.Press [
p] [q] to select “Uilities” and press
[
u].
3.Press [
p] [q] to select “Add/Delete” and press
[ENTER] to bring up the add/delete menu.
Swapping TV channel manually (following TV)
This function allows users to manually swap the TV channel order stored in DVD-Recorder to match the TV channel order stored in users’ TV set.
1.Press [SETUP] to display the “SETUP” menu, press [
p] [q] to select the “TV TUNER” icon
and press [
u].
2.Press [
p] [q] to select “Swap” and press
[ENTER] to bring up the “SWAP” menu.
3.Select the TV channel(s) to be swapped and press [ENTER] to mark it/them.
4.Press [
p] [q][t] [u] to select a new channel
position and press [ENTER] to swap.
13
5.To swap more TV channels, repeat step “3” to complete the settings.
6.Select “EXIT” to save the setting and exit the
“SWAP” menu.
