Wireless thermostat set „FS20 STR“

2. Mounting the wall holder

Proceed as follows to mount the device:

• Slide down and remove the wall holder on the back of the wireless thermostat.

• Place the wall holder vertically against the wall with the round side pointing up, see figure 4.

• Mark the positions of the bores through the two slotted holes, see arrows in figure 4.

• Depending on the type of wall, drill 6mm holes and insert suitable dowels.

p p

Figure 4

Make sure no electrical cables, gas or water pipes are damaged! Lifethreatening danger!

• Fix the wall holder into place using, for example, the enclosed screws. Make sure that the two recessed slotted holes for the screws point in your direction.

• If you have not already done so, insert the batteries into the wireless thermostat (see section

6. a) before you slide it on to the wall holder.

• The wireless thermostat can now be slotted down on to the wall holder from above.

21