Safety Instructions. ACTi E31, E34, E33, E32

Add to My manuals
33 Pages

advertisement

Safety Instructions. ACTi E31, E34, E33, E32 | Manualzz

Hardware Manual

Safety Instructions

Don’t open the housing of the product

Cleaning

Disconnect this video product from the power supply before cleaning.

Attachments

Do not use attachments not recommended by the video product manufacturer as they may cause hazards.

Water and Moisture

Do not use this video product near water, for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool and the like.

Don’t use accessories not recommended by the manufacturer

Only install this device in a dry place protected from weather

Servicing

Do not attempt to service this video product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

Damage Requiring service

Disconnect this video product from the power supply immediately and refer servicing to qualified service personnel under the following conditions.

1) When the power-supply cord or plug is damaged

2) If liquid has been spilled, or objects have fallen into the video product.

3) If the video product has been directly exposed to rain or water.

4) If the video product does not operate normally by following the operating Instructions in this manual. Adjust only those controls that are covered by the instruction manual, as an improper adjustment of other controls may result in damage, and will often require extensive work by a qualified technician to restore the video product to its normal operation.

Safety Check

Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to determine if the video product is in proper operating condition.

6 www.acti.com

advertisement

Related manuals

Frequently Answers and Questions

How do I reset the ACTi E32 camera to its factory default settings?
While the camera is powered on, press and hold the Reset button for 5 seconds or until the Power LED lights up.
What does the Power LED indicate?
The Power LED lights up when the camera is connected to a power source and starts the boot-up process. After the boot process is complete, the Power LED goes off.
How do I connect the ACTi E32 camera to the Ethernet network?
Use an Ethernet cable to connect the Ethernet port of the camera to the Ethernet network.
What is the recommended type of Ethernet cable for outdoor installations?
For outdoor installations, use exterior-grade Ethernet cables (CAT5/CAT5e/CAT6) which are waterproof and do not require a conduit. Ordinary Ethernet cables are only designed for indoor use.
How do I waterproof the cable connection for outdoor installations?
Enclose the cable connection inside a junction box or use a weatherproof enclosure.
How do I adjust the viewing angle of the ACTi E32 camera?
Loosen the knob on the camera bracket, adjust the camera angle, and then tighten the knob to fix the camera position.