advertisement
▼
Scroll to page 2
of
33
Physical Description
Hardware Manual
1) Reset Button
Use the Reset Button to reset the camera to its factory default settings. While the camera is powered on, press and hold the Reset button for 5 seconds or until the Power LED lights up.
2) Power LED
The Power LED lights up when the camera is connected to the power source and the camera starts the boot up process. Then, the Power LED goes off when the boot process is complete.
3) Ethernet Port
Use the Ethernet Port to connect the camera to the Ethernet via a standard RJ45 connector.
advertisement
Related manuals
Frequently Answers and Questions
How do I reset the ACTi E32 camera to its factory default settings?
While the camera is powered on, press and hold the Reset button for 5 seconds or until the Power LED lights up.
What does the Power LED indicate?
The Power LED lights up when the camera is connected to a power source and starts the boot-up process. After the boot process is complete, the Power LED goes off.
How do I connect the ACTi E32 camera to the Ethernet network?
Use an Ethernet cable to connect the Ethernet port of the camera to the Ethernet network.
What is the recommended type of Ethernet cable for outdoor installations?
For outdoor installations, use exterior-grade Ethernet cables (CAT5/CAT5e/CAT6) which are waterproof and do not require a conduit. Ordinary Ethernet cables are only designed for indoor use.
How do I waterproof the cable connection for outdoor installations?
Enclose the cable connection inside a junction box or use a weatherproof enclosure.
How do I adjust the viewing angle of the ACTi E32 camera?
Loosen the knob on the camera bracket, adjust the camera angle, and then tighten the knob to fix the camera position.
advertisement