Mount the Camera. ACTi E31, E34, E33, E32

Add to My manuals
33 Pages

advertisement

Mount the Camera. ACTi E31, E34, E33, E32 | Manualzz

Hardware Manual

Installation Procedures

Mount the Camera

Using the Bundled Bracket

1.

Mark the location of the three (3) screw holes using the bracket plate included in the package.

NOTE:

Depending on the surface where you will install the camera, it may be necessary to drill the holes and use the supplied screw tox.

2.

Attach the plate to the surface using the three (3) supplied screws.

3.

Attach the bracket to the plate.

10 www.acti.com

Hardware Manual

4.

Depending on how you want to install the camera, attach the camera to the bracket through one of the two (2) holes below:

If the camera will be installed indoors and the use of sunshield is not necessary, you may also use one of the two (2) holes on top of the camera to mount the bracket to the ceiling.

First, remove the pre-installed screw nut using a wrench (not included in the package).

5.

Adjust the camera viewing angle and tighten the knob to fix the camera position.

Depending on the camera angle, you may also need to tighten the two (2) screws using the star wrench (included in the package) to fix the camera position.

11 www.acti.com

Hardware Manual

6.

Connect an Ethernet cable from the network side to the Ethernet port of the camera to

complete the installation. See

Basic Connections

on page 23 for more information.

Camera Side

Network Side

NOTES on using Ethernet cables:

For outdoor installations, it is recommended to use

exterior-grade

Ethernet cables (CAT5/CAT5e/CAT6); ordinary Ethernet cables are only designed for indoor use and may deteriorate quickly when exposed to outdoor elements.

Exterior-grade Ethernet cables are waterproof and do not require a conduit.

CAUTION:

If the camera will be installed outdoors, be sure to waterproof the cable connection by enclosing it inside a junction box or wrap it using a moisture-sealant tape, such as

3M PRODUCTS Core Series 4-1000

(not included in the package) or equivalent.

See example below.

For other waterproofing methods, see

Waterproof Cable Installation

on page 14.

12 www.acti.com

advertisement

Related manuals

Frequently Answers and Questions

How do I reset the ACTi E32 camera to its factory default settings?
While the camera is powered on, press and hold the Reset button for 5 seconds or until the Power LED lights up.
What does the Power LED indicate?
The Power LED lights up when the camera is connected to a power source and starts the boot-up process. After the boot process is complete, the Power LED goes off.
How do I connect the ACTi E32 camera to the Ethernet network?
Use an Ethernet cable to connect the Ethernet port of the camera to the Ethernet network.
What is the recommended type of Ethernet cable for outdoor installations?
For outdoor installations, use exterior-grade Ethernet cables (CAT5/CAT5e/CAT6) which are waterproof and do not require a conduit. Ordinary Ethernet cables are only designed for indoor use.
How do I waterproof the cable connection for outdoor installations?
Enclose the cable connection inside a junction box or use a weatherproof enclosure.
How do I adjust the viewing angle of the ACTi E32 camera?
Loosen the knob on the camera bracket, adjust the camera angle, and then tighten the knob to fix the camera position.