Using the Default Camera IP Address. ACTi E31, E34, E33, E32

Add to My manuals
33 Pages

advertisement

Using the Default Camera IP Address. ACTi E31, E34, E33, E32 | Manualzz

Hardware Manual

Using the Default Camera IP Address

If there is no DHCP server in the given network, the user may have to assign the IP addresses to both PC and camera manually to make sure they are in the same network segment.

When the camera is plugged into network and it does not detect any DHCP services, it will automatically assign itself a default IP:

192.168.0.100

Whereas the default port number would be

80

. In order to access that camera, the IP address of the PC has to be configured to match the network segment of the camera.

Manually adjust the IP address of the PC:

In the following example, based on Windows 7, we will configure the IP address to

192.168.0.99

and set Subnet Mask to

255.255.255.0

by using the steps below:

1 2

3

4

27 www.acti.com

Hardware Manual

Manually adjust the IP addresses of multiple cameras:

If there are more than 1 camera to be used in the same local area network and there is no

DHCP server to assign unique IP addresses to each of them, all of the cameras would then have the initial IP address of

192.168.0.100

, which is not a proper situation for network devices

– all the IP addresses have to be different from each other. The easiest way to assign cameras the IP addresses is by using

IP Utility

:

With the procedure shown above, all the cameras will have unique IP addresses, starting from

192.168.0.101. In case there are 20 cameras selected, the last one of the cameras would have the IP 192.168.0.120.

Later, by pressing the

“Refresh” button of the IP Utility, you will be able to see the list of cameras with their new IP addresses.

Please note that it is also possible to change the IP addresses manually by using the Web browser. In such case, please plug in only one camera at a time, and change its IP address by using the Web browser before plugging in the next one. This way, the Web browser will not be confused about two devices having the same IP address at the same time.

28 www.acti.com

advertisement

Related manuals

Frequently Answers and Questions

How do I reset the ACTi E32 camera to its factory default settings?
While the camera is powered on, press and hold the Reset button for 5 seconds or until the Power LED lights up.
What does the Power LED indicate?
The Power LED lights up when the camera is connected to a power source and starts the boot-up process. After the boot process is complete, the Power LED goes off.
How do I connect the ACTi E32 camera to the Ethernet network?
Use an Ethernet cable to connect the Ethernet port of the camera to the Ethernet network.
What is the recommended type of Ethernet cable for outdoor installations?
For outdoor installations, use exterior-grade Ethernet cables (CAT5/CAT5e/CAT6) which are waterproof and do not require a conduit. Ordinary Ethernet cables are only designed for indoor use.
How do I waterproof the cable connection for outdoor installations?
Enclose the cable connection inside a junction box or use a weatherproof enclosure.
How do I adjust the viewing angle of the ACTi E32 camera?
Loosen the knob on the camera bracket, adjust the camera angle, and then tighten the knob to fix the camera position.