Bosch Solution 16 V2.1 Inst Manual

Programming 23

Installers Programming Commands

There are several commands that can be invoked to perform various functions once the Installer's Programming Mode has been entered. To invoke the command, enter the corresponding numerical code followed by the button

Command

958

959

960

961

962

963

964

965

966

999

Function

Enable and Disable Zone Status Mode

Test Programming Key

Exit Installer’s Programming Mode

Reset Control Panel Back To Factory Default Settings

Copy The Control Panel Memory To The Programming Key

Copy The Programming Key Data To The Control Panel

Erase Programming Key

Set Up Domestic Dialling Format

Enable and Disable Automatic Stepping Of Locations During Programming

This Command Displays The Control Panel’s Software Version Number Only When

Using The Hand Held Programmer

Table 4: Installer's Programming Commands

Command 958 - Enable/Disable Zone Status Mode

This function enables and disables the zone status display mode. When using the hand held programmer, the zones will be displayed on the seven segment displays from left to right. If there is a dash illuminated on the display, the corresponding zone is unsealed and if the display is blank, the zone is sealed.

The third (or centre) display shows either the number 4 or the number 8. The number 4 constantly illuminated indicates that zones 1 - 4 are being displayed. The number 8 constantly illuminated indicates that zones 5 - 8 are being displayed. The number

4 flashing indicates zones 9 - 12 are being displayed. The number 8 flashing indicates that zones 13 - 16 are being displayed.

Pressing the

#

button will toggle the display between the zones. This feature will prove to be very useful during installation as it allows you to view the status of the zones directly at the control panel, saving you time and money.

How To Enable Zone Status Mode

1.

2.

Enter Installers Programming Mode.

Enter command

958

followed by the

#

button.

Two beeps will be heard.

How To Disable Zone Status Mode

1.

Enter command

958

followed by the

#

button.

Two beeps will be heard.

Example

A " - " in the display indicates the zone is triggered.

A blank display indicates the zone is normal.

--4--

indicates that zones 1, 2, 3 and 4 are triggered.

A flashing "4" indicates zones 9, 10, 11 and 12 are being displayed.

À8À

indicates that zones 5 and 8 are triggered.

A flashing "8" indicates zones 13 and 16 are being displayed.

Electronics Design & Manufacturing Pty Limited ISSUE210.DOC