advertisement
System Functions 49
7 Telephone Monitor Mode On and Off
Telephone monitor mode allows the remote codepad to be used for a visual representation of data transmissions between the control panel and the base station receiver. The dialling sequence is also shown in this mode.
The codepad will beep once every two seconds while telephone monitor mode is turned on regardless of whether the system is in Installer's Programming Mode or normal operating mode. The first five indicators are used to display the progressive steps for a transmission to the base station receiver.
Zone LED
1
2
3
4
5
None
Dialling Event
Telephone Line Seized
Dialling Phone Number
Handshake Received
Data Is Being Transmitted
Kiss-Off Received
Telephone Line Released
Table 17: Telephone Monitor Mode Indications
How To Turn Telephone Monitor Mode On
1.
Enter your
Three beeps will be heard.
followed by
7
and the button.
+
7
+
How To Turn Telephone Monitor Mode Off
1.
Enter your
Two beeps will be heard.
followed by
7
and the button.
+
7
+
note: To test the on-board dialler, you will need to program Option 1 – Disable Safecom Communication
Reporting in LOCATION 896 before you power down the system and re-apply the power for the on-board dialler to operate or have the base station perform a reframe of the Safecom System.
After you have successfully tested the reporting of the on-board dialler, you will need to disable Option 1 in LOCATION 896 and then power down the system or have the base station perform a reframe of the
Safecom System.
Electronics Design & Manufacturing Pty Limited ISSUE210.DOC
advertisement
Related manuals
advertisement