advertisement
▼
Scroll to page 2
of
105
phyCORE-MPC5200B tiny/IO QuickStart Instructions
4.3 Setting a breakpoint
Now you will set a breakpoint in your program. The breakpoint will be set in the last line of the main function. If you resume the application, the debugger will stop in this line.
•
Select the last line in main.
•
Right-Click left in the small grey border and select Toggle
Breakpoint
to set a new breakpoint.
92
© PHYTEC Messtechnik GmbH 2007 L-679e_5
advertisement
Related manuals
advertisement
Table of contents
- 4 Introduction
- 4 Rapid Development Kit Documentation
- 5 Professional Support Packages available
- 5 Overview of this QuickStart Instruction
- 6 Conventions used in this QuickStart
- 7 System Requirements
- 8 The PHYTEC phyCORE-MPC5200B tiny/IO
- 11 Software Development Toolchains
- 11 Eclipse
- 12 The Gnu Cross Development Toolchain
- 13 Getting Started
- 13 Requirements of the Host Platform
- 14 Configuring the Host Platform
- 14 Installing Software packages
- 20 Setup Network Card Configuration
- 23 Disabling the Firewall
- 24 Setup TFTP-Server
- 26 Linux-PowerPC-Kit Setup
- 36 Connecting the host with the target
- 42 Copying an Example to the Target
- 51 Getting More Involved
- 51 Configuring and Compiling the Kernel
- 55 Writing the Kernel into Flash
- 60 Opening an Existing Project
- 66 Creating a New Project
- 76 Changing the Demo
- 78 Starting a program out of Eclipse on the target
- 82 Starting the program when booting the target
- 87 Debugging an Example Project
- 87 Starting the GDB-Server on the target
- 89 Configuring and starting the debugger in Eclipse
- 94 Setting a breakpoint
- 95 Stepping and Watching Variables Content
- 97 Changing Variables Values
- 99 Using the Memory Monitor
- 102 Further Information
- 103 Summary