Forced logoff of another user by the administrator
The configuration of the system can always only be edited by one user.
Working on the configuration in parallel is not possible. This ensures that no configuration conflicts arise.
If the user “Administrator” logs in and another user with administration rights is already logged in, then the administrator can forcibly log the other user off in order to configure. This functionality, for example can be used, when configuring remotely, when a user has forgotten to log out.
In order to forcibly log a user off:
1. The “Administrator” user logs-in with the administration password.
2. They open the Configurator.
A message shows which user is currently configuring the system.
3. The administrator clicks on the
Take over config rights button.
The other user can make no further modifications of the configuration.
Codes for IP
Configuration
The IP configuration of the
OpenCom 100 is performed on the
Web console in the Configurator, in the NET Configuration: Easy Access menu.
In the event that the IP configuration of the OpenCom 100 has to be changed and access via the Web console is not possible, you can also use a code digit procedure to change these basic settings. Entry can be made from an analogue telephone, an ISDN telephone and from system telephones.
Ask your system administrator for the OpenCom 100 system PIN. The factory setting is “0000”.
Set IP address
H * 1 8 2 Z (system PIN)
* Z (www) * Z (xxx) *
Z (yyy) * Z (zzz) #
Set NET mask
H * 1 8 3 Z (system PIN)
* Z (www) * Z (xxx) *
Z (yyy) * Z (zzz) #
Restart
H * 1 8 5
Z (system PIN) #
Configuration Configuring the OpenCom 100
77
