advertisement
Assembly
Adjust Throttle Lever Free Play
The throttle lever free play should be approximately 3/16-1/4 inch (4-6 mm). See Figure 6. Make sure that the throttle lever operates smoothly without binding.
If it becomes necessary to adjust the lever free play, follow the procedures and illustrations that follow.
1. Loosen the air cleaner cover knob and remove the air cleaner cover.
See Figure 7.
2. Loosen the lock nut on the cable adjuster. See Figure 8.
3. Turn the cable adjuster in or out as required to obtain proper free play
3/16-1/4 inch (4-6 mm). See Figure
8.
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
Figure 7
Front handle installation
NOTE:
Label shows minimum spacing for front handle location.
1. Position front handle for comfortable operation and secure screw.
251043
Figure 6
Cable
Adjuster
Lock
Nut
3/16-1/4 inch (4-6 mm)
Throttle Free Play
Figure 8
Handle
Outer
Tube
Screw
Install the Cutting Attachment Shield
1. Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate.
See Figure 9.
NOTE:
It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over the outer tube and loosely install the four sockethead screws. See Figure 9.
3. Tighten the four socket-head cap screws to secure the cutting attachment shield.
4. Re-tighten clamp screw and retaining nut.
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Figure 9
Retaining
Nut
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket-head cap screws.
Outer
Tube
T242
Cutting
Attachment
Shield
Nuts
Cutting
Attachment
Mounting
Plate
Shim
Line Cutter
Figure 9A
26013
Hex
Screws
WARNING!
NEVER operate the unit with- out the cutting attachment shield installed and tightly secured!
7
advertisement
Related manuals
advertisement