Long Term Storage. Shindaiwa T242

Add to My manuals
24 Pages

advertisement

Long Term Storage. Shindaiwa T242 | Manualzz

Loading

Speed-Feed

© Trimmer Line

1. Cut one piece of line to recommended length.

.080 (2.0 mm) dia. – 20’ (6 m)

.095 (2.4 mm) dia. – 20’ (6 m)

2. Align arrows on top of knob with openings in eyelets.

3. Insert one end of trimmer line into an eyelet, and push line equal distance through trimmer head.

4. Hold trimmer head while turning knob clockwise to wind line onto spool until about 5” (13 cm) of each line remains exposed.

Trimmer head is now fully loaded and ready for operation.

2

3

4

IMPORTANT!

When the wear indicators located at the bottom of the Speed-Feed head are worn smooth, or if holes appear, replacement of the cover or the entire Speed-Feed head is required.

Wear Indicators

Wear Indicators

Long Term Storage

Whenever the unit will not be used for

30 days or longer, use the following procedures to prepare it for storage:

Clean external parts thoroughly and

Drain all the fuel from the carburetor and the fuel tank.

To do so:

1. Prime the primer bulb until no more fuel is passing through.

2. Start and run the engine until it stops running.

3. Repeat steps 1 and 2 until the engine will no longer start.

CAUTION!

Gasoline stored in the carburetor for extended periods can cause hard starting, and could also lead to increased service and maintenance costs.

IMPORTANT!

All stored fuels should be stabilized with a fuel stabilizer such as STA-BIL™.

NOTE:

Damage resulting from stale or contaminated fuel is not covered by the

Shindaiwa warranty policy.

Remove the spark plug and pour about 1/4 oz. of engine oil into the cylinder through the spark plug hole.

Slowly pull the recoil starter 2 or 3 times so oil will evenly coat the interior of the engine. Reinstall the spark plug.

Indicadores de desgaste

Before storing the unit, repair or replace any worn or damaged parts.

Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water. Let dry and reassemble the element.

Store the unit in a clean, dust-free area.

17

Indicateurs d’usure

Indicateurs d’usure

advertisement

Related manuals