MICOM-3F/3T/3R HF-SSB Owner’s Guide
Programming Channels
➤
To enter the Channel Programming mode:
1. Enter the Radio Programming menu (page 79).
MICOM-3
RADIO
PROGRAMMING
CHAN
PRMT
OPTS
2. Press (F1).
MICOM-3
CHAN
PARAMETERS
GET
STOR
I
USB
PWR
The CHAN menu provides the following options (see also Figure 6):
• GET GET retrieves a channel already programmed in MICOM-3. Retrieving a channel retrieves all the parameters defined for that channel. You can store these parameters as a new channel using the STOR function, and then edit the parameters as required.
• STOR Store the current set of parameters in a selected channel.
Note
GET and STOR are used to copy the channel parameters from one channel to another.
• ERAS ERAS is used to delete (erase) a channel. Actually, this action only replaces the user-modified parameters of the channel with the factory-default parameters, but marks the channel as not programmed.
• PWR Select the channel transmit power level. Four transmit power levels can be selected:
• LOW – 25 W nominal
• MED – 62.5 W nominal
• HIGH – 100 W nominal
• MAX – 125 W nominal.
• FREQ Select the channel frequency. MICOM-3 offers four frequency options:
• SMPX (Simplex Frequency): the same frequency is used for both transmission and reception.
• DPLX (Duplex Frequency): transmits on one frequency and receives on a different frequency.
• RXO (Receiving Only Frequency): defines a frequency for reception only.
Transmission on that frequency is disabled.
• TXO (Transmitting Only Frequency): defines a frequency for transmission only. You cannot receive on that frequency.
82
Programming the Radio Parameters
Note
The available frequency ranges are: • Reception: 100 kHz to 30 MHz.
• Transmission: 1.6 to 30 MHz.
• BAND Select the channel SSB mode:
• USB – upper sideband mode
• LSB – lower sideband mode.
• MODE Select the channel radio operating mode:
• SSB – single sideband
• AME – amplitude modulation equivalent
• PLT – single sideband with pilot signal.
• AGC Select the channel Automatic Gain Control mode. MICOM-3 offers two AGC response speeds: SLOW and FAST. You can also turn the AGC OFF completely.
• BW Select the default channel filter bandwidth:
• 2.1 K
• 2.7 K
• 3.0 K
• 3.3 K
• LSM (Low Speed Modem)
• CW (Continuous Wave). The bandwidth used in this case is selected by
MENU
>
PROG
>
RAD
>
PRMT
>
CW
.
Note
The factory-default parameter values are as follows:
• Rx Frequency
15.000.00 MHz
• Tx Frequency
15.000.00 MHz
• SSB Mode (Band) USB
• Bandwidth 2.7K
• Tx Power
• AGC Type
MAX
SSB
83