HP-PB 100Base-T Network Adapter Installation and Service Guide

Installation Procedure

5. Configure the Adapter into the System

5. Configure the Adapter into the System

On MPE systems you will need to configure the adapter into the system.

In particular you must specify link auto-negotiation, speed, and duplex settings to match those of the network hub/switch port to which you attached the adapter. For more information on MPE systems, refer to:

• NS3000/iX NMMGR Screens Reference Manual (36922-61003)

• HP3000/iX Network Planning and Configuration Guide

(36922-61023)

• System Startup, Configuration, and Shutdown Reference Manual

(32650-90042)

Chapter 1 21