DIGIPASS Authentication for Epic Hyperspace Administrator Guide Configuring DIGIPASS Authentication Module
4.1
Using the DIGIPASS Authentication for Epic Hyperspace Configuration Center
A graphical user interface (GUI) called
DIGIPASS Authentication for Epic Hyperspace Configuration
Center
is available to configure the DIGIPASS Authentication Module . This provides a simple, intuitive way to set up the DIGIPASS Authentication Module to work with your current system.
If this is the first time you have opened the
DIGIPASS Authentication for Epic Hyperspace Configuration
Center
and the configuration file has not been edited, the values you will see are those entered when the wizard was last run.
4.1.1
Starting DIGIPASS Authentication Module Configuration Center
To start the DIGIPASS Authentication Module Configuration Center
Do one of the following:
• Select Start > All Programs > VASCO > DIGIPASS Authentication Modules >
DPAuth4EHS Config Center.
-OR-
•
Open Windows Explorer and launch
<installation_folder\VASCO DIGIPASS Authentication for Epic
Hyperspace Configuration Center.exe
.
4.1.2
Configuring Servers and Connections
To add and configure authentication servers
1.
Start the
DIGIPASS Authentication for Epic Hyperspace Configuration Center
and select
Servers
and Connections.
31
DIGIPASS Authentication for Epic Hyperspace Administrator Guide Configuring DIGIPASS Authentication Module
Figure 12: Configuring Servers and Connections (1)
2.
Do one of the following:
• Click Add if you want to add a new authentication server.
-OR-
• To modify the settings of an authentication server, select the server from the Authentication
servers list.
Move servers up and down as needed. With multiple authentication servers, DIGIPASS Authentication for
Epic Hyperspace will connect to the topmost server. If this server is not available, the DIGIPASS
Authentication for Epic Hyperspace will attempt to connect to the next server in the list.
The Configuration for <authentication_server> section appears.
32
DIGIPASS Authentication for Epic Hyperspace Administrator Guide Configuring DIGIPASS Authentication Module
Figure 13: Configuring Servers and Connections (2)
3.
Select an IP address in Connect from IP address from which to connect to the authentication server.
For more information, see 2.4.1 Connection Profiles .
4.
Specify the server details:
•
Display name: Type a name for the authentication server in this field. This name is then used to distinguish the authentication server in the
Authentication servers list, but has no effect on the behaviour of the DIGIPASS Authentication Module
.
•
IP address: Type the IP address of the authentication server.
• SEAL port: Type the port for the authentication server. The default port is
20003 for standard, and
20004 for SSL connections.
• Use SSL: Select this if you want to use SSL when connecting to the authentication server
•
Server type: Select the server type. For more information, see
2.4.1 Connection Profiles .
5.
(OPTIONAL) Click Test to test if a connection to the authentication server can be established. A message will appear indicating if the test was successful.
6.
Specify the connection parameters.
• Timeout (in sec): Specify a timeout period in seconds.
• Maximum Connections: Specify the maximum number of concurrent connections to be made from the DIGIPASS Authentication Module to the authentication server.
33
