DIGIPASS Authentication for Epic Hyperspace Administrator Guide
5
Post-Installation Tasks
Post-Installation Tasks
This chapter lists and describes tasks you need to complete after installing the
DIGIPASS Authentication
Module
.
This chapter covers the following topics:
•
Enabling the Response-Only Login or 2-Step Challenge/Response Login
•
Enabling the 1-Step Challenge/Response Login Page
47
DIGIPASS Authentication for Epic Hyperspace Administrator Guide Post-Installation Tasks
5.1
Enabling the Response-Only Login or 2-Step Challenge/Response Login
The
General section allows the administrator to enable or disable DIGIPASS Authentication for Epic
Hyperspace; the Authentication section defines which authentication methods are available when DIGIPASS
Authentication for Epic Hyperspace is enabled.
To enable response-only and 2-step challenge/response authentication, select Response-Only and 2-Step
Challenge/Response login (see Figure 17).
NOTE
If you would like end users to use Virtual DIGIPASS, select Enable Virtual DIGIPASS login.
Figure 17: Enabling Response-Only and 2-Step Challenge/Response
48
DIGIPASS Authentication for Epic Hyperspace Administrator Guide Post-Installation Tasks
5.2
Enabling the 1-Step Challenge/Response Login Page
To enable 1-step challenge/response authentication, select 1-step Challenge/Response login (see Figure
18).
NOTE
If you would like end users to use Virtual DIGIPASS, select
Enable Virtual DIGIPASS login.
Figure 18: Enabling 1-Step Challenge/Response
49
