2007 Electrolux Side-By-Side Refrigerator Service Manual

Section F - Ice Maker

EXAMPLE: An ice maker is test-cycled and the water fill sample is 93 cubic centimeters.

Subtracting 80 cc from 93, the adjustment needed is 13 cc. Since one turn of the adjusting screw changes the fill 18 cc, ¾ of a turn clockwise would reduce the fill about 13 cc, the desired amount.

(This example is for manual models only.)

Parts Replacement

Disconnect electrical supply to refrigerator.

To Replace Front Cover (Figure F4)

1. Remove ice maker from freezer.

2. Ensure that ice maker is at room temperature before removing Cover.

3. Remove screw at the top of the cover and tip it out until the tab at the bottom comes out of the housing.

5. Install in reverse order.

To Replace Ice Stripper (Figure F5)

1. Remove ice maker from freezer.

2. Pull out on the stripper about 1 inch back from the front the ice maker till the retaining tab is away from the tab on the ice mold.

3. Pull back on ice stripper to disengage it from front of mold support housing.

4. Replace in reverse order.

To Replace Fill Trough (Figure F6)

1. Remove ice maker form Freezer.

2. Push trough retaining tab back against the mold.

3. Pull the trough up until it is clear of the mold.

4. Replace in reverse order.

Figure F 4

To Replace Ejector Blades (Figure F5)

1. Remove ice maker form freezer.

2. Remove front cover.

3. Remove two screws holding mounting plate in place.

4. Carefully remove mounting plate, disengaging end of ice maker control arm and ejector blades from motor coupling, noting relative position of ice maker control arm spring.

5. Remove fill trough and bearing.

6. Turn blades to 12 O’clock position.

7. Slide ejector blades back and up to remove.

8. Replace in reverse order.

9. Lubricate bearing ends of ejector with

On Off Switch

Fill Trough

Ice Mold

Ice Ejector

Figure F 5

Ice Stripper

Sensing Arm