advertisement
TracVision A5 Installation Guide
4-2 Post-installation Checklist
Congratulations! You’ve completed the TracVision A5 installation. Before you turn on and test the system, please make certain that you have completed the following important steps:
Step
You affixed the antenna serial number label to the red Activation Card
.
You attached the mounting brackets using the supplied TORX screws.
You removed the antenna’s shipping restraints from below.
Rack Mount: You verified the vehicle’s roof rack crossbars are securely fastened to the vehicle and are sturdy enough to support the antenna.
Rack Mount: You positioned the rubber cushions within the antenna mounting brackets/retaining blocks to best fit the vehicle’s crossbars.
Page #
1.9
2.3
2.4
2.5
2.6
Roof Mount: You installed and sealed eight jack nuts in the vehicle’s roof 2.13
to mount the antenna.
You allowed enough clearance between the antenna and the roof.
You secured the antenna to the vehicle using the TORX hardware.
After connecting the antenna cable to the antenna, you installed the rubber boot over the connector.
2.7, 2.11
2.8, 2.14
2.17, 2.21
4.4
Done?
54-0208-01
Step
If you routed the antenna cable through the roof, you used the supplied fitting and backing plate and sealed the holes.
You recorded the new height of the vehicle and informed the user.
You did not disconnect the short cable pre-connected on the receiver’s rear panel.
If you cut the antenna cable, you used an LRC/Augat T1000 tool to attach the supplied F-connector to the end of the cable.
You connected the antenna cable to the receiver.
You connected the RF converter to the receiver and placed it
3 feet away from the receiver and other electronic devices.
You connected high-quality audio/video cables from the receiver to the vehicle’s entertainment system.
You connected the receiver’s power cable to +12 VDC switched
(accessory) power and did not connect other devices to the same circuit.
You mounted the receiver in a dry location away from any heat sources and allowed plenty of room for ventilation.
Receiver Location:
Page #
2.19
2.22
3.3
3.5
3.8
3.8
3.9
3.12
3.14
4.3
You installed two “AAA” batteries in the remote control.
54-0208-01
Done?
Completing the Installation
4.5
advertisement