Save button
Figure 38: Save button with dynamic label
Note
The button circled in the illustration above is dynamic in that it may have one of three possible labels ( Save,
Delete, or Rename), depending on user choices.
•
Save: When you select an existing custom paper size, or when you change the height or width setting, the button is labeled Save.
•
Delete: After you select or save an existing custom paper size, the button is labeled Delete.
•
Rename: When you select an existing custom paper size, and then type into the Name drop-down menu, the button is labeled Rename.
Width and height controls
The width and height values can be changed either by typing numeric strings into the edit boxes, or by using the up and down arrows.
Any entry that is greater than the maximum limits of the width and height control is rounded down to the maximum valid entry, while any entry that is smaller than the minimum limits of the width and height control is rounded up to the minimum valid entry. See the "Custom width and height control limits" section of this guide.
If units are in millimeters, the custom paper-size range minimum is the limit rounded up to the nearest whole millimeter. The custom paper-size range maximum is the limit rounded down to the nearest whole millimeter. Any nonnumerical entry reverts to the last valid entry. Width and height entries are validated when the focus has changed.
The resolution of each control is one millimeter or one-tenth of an inch, depending on the current measurement units.
Clicking the up and down arrows increases or decreases the current value by the increment amount (within the allowed range of values). The computer determines the rate at which the values change.
114
HP traditional PCL 6 driver features Software Technical Reference ENWW
