Changing the DISP (screen display) setting. Sony DSCT90S, DSCT90L, DSCT90B, DSCT90P, 4-130-938-12(1), DSCT90T, Cyber-shot 4-130-938-12(1)

Changing the DISP (screen display) setting

Touch on the screen to change to the display selection screen.

Note

• Settings other than [Brightness] should be made separately for shooting and playback.

Display Setup

This sets whether or not to display the operation buttons and icons on the screen.

(Normal)

The operation buttons and the icons are displayed.

(Simple)

Only the operation buttons are displayed.

(Image Only)

The operation buttons and the icons are not displayed.

z

Using [Image Only] playback

• Select an image by touching the left and right sides of the screen.

When you touch the center of the screen, [Normal] display mode is selected temporarily. Touch on the upper right corner of the screen to return to [Image Only] display mode.

• In [Normal] or [Simple] display mode, touch to switch to

[Image Only] display. Touch the center of the screen to return to the previous display mode.

17 GB

Wide Zoom

In single-image mode, still images at a 4:3 and 3:2 aspect ratio are played at a 16:9 aspect ratio.

In this case the top and bottom of the image will be slightly cropped.

Note

• Wide Zoom is not available for movies or 16:9 images.

Histogram

A histogram is a graph showing the brightness of an image. The graph display indicates a bright image when skewed to the right side, and a dark image when skewed to the left side.

A

Number of pixels

B Brightness

A

Dark

B

Bright

Notes

• The histogram also appears when playing back a single image, but you cannot adjust the exposure.

• The histogram does not appear while recording movies, playing back movies, viewing vertical orientation images, rotating still images, using Temporarily Rotated Display, or using Wide Zoom (4:3,

3:2).

• A large difference in the histogram displayed during shooting and playback may occur when:

– The flash strobes.

– The shutter speed is slow or fast.

• The histogram may not appear for images recorded using other cameras.

Brightness

This sets the brightness of the LCD screen. When viewing images in bright outside light if

[Brightness] is set to [Normal], reset to [Bright]. However, the battery power may decrease faster under such condition.

Number of Images

You can set the number of images displayed in index screen to 12 or 20 images.

18 GB