- Home
- Domestic appliances
- Large home appliances
- Fridge-freezers
- Liebherr
- HC1540
- Installation instructions
advertisement
B lockInG for
s afety
Mounting the Anti Tipping Device
- Figures 8 - 11
• The anti tipping bracket must be mounted to prevent the appliance from tipping when the fully stocked door is opened.
• Be sure that there is no plumbing or electrical wiring located in this area which screws or drills could damage.
The anti tipping bracket is provided with the appliance.
1. Mark the center line of the appliance on the back wall. Align the anti tipping bracket center to this line.
2. Depending on the constitution of the floor and wall, use any possible mounting option as shown in
Figures 8 - 11.
Mounting Options
IMPORTANT
The anti tipping bracket must be fitted at the same height as the toe kick area. If you set the appliance to a higher level by laying spacers underneath, the anti tipping bracket must be fitted accordingly.
Mounting the bracket with the wall stud.
Mounting with wall plugs to concrete walls
(Figure 8).
Screws 6 x 63 mm
Mounting with wooden floors
(Figure 10).
Screws 6 x 63 mm
Wall
Floor
Figure 8
Wall
Floor
Figure 10
Mounting with concrete floors using the anchors provided
(Figure 11).
Mounting with the wall plate turning in the screws at an angle
(Figure 9).
Screws 6 x 63 mm
Wall
Floor
Figure 9
Wall
Floor
Figure 11
8
advertisement
Related manuals
advertisement
Table of contents
- 4 Unit dimensions
- 4 Door swing clearance
- 4 Unit venting
- 7 frameless cabinet design
- 8 Mounting the anti tipping device
- 8 Mounting options
- 9 deeper than
- 9 Cover strips
- 10 Safety instructions and warnings
- 10 Water connection
- 10 Connection to the water supply
- 12 Leveling the appliance
- 12 Fastening the appliance in the recess
- 13 Adjusting the refrigerator door
- 13 Adjusting the drawer front
- 14 Before mounting the door panels
- 15 onto the door panels
- 16 Mounting the refrigerator door panel
- 18 Mounting the freezer drawer panels
- 18 Mounting the ventilation grille