Step d) e) f)
Press Displayed
AUDIO SETUP
IP SETUP
RF SETUP
From RF Setup, set the LNB DC Power.
iPump6400 User’s Manual
Screen Type
Menu
Menu
Menu b) c) d)
Step a)
Press
ENTER
Displayed/Field Details
RF STATUS:
TRACKING: Eb/No = XX.X
RF status is shown. If tracking, then Eb/N0 is also displayed.
CURRENT CHANNEL
LNB TYPE
Select ON or OFF.
LNB DC POWER
Screen Type
Data Display
Menu
User Input -
Selectable
User Input -
Selectable
Date/Time
Setup
NOTE: When operating under the Compel network, date and time settings are overwritten by Compel. Time zone and Daylight Savings Time settings, however, remain under local control and should be set by the user.
Set up the date and time for your iPump6400 during the initial setup. First navigate to the Date/Time Setup screen. (Date/Time setup may also be performed from the browser interface under the SETUP tab.) wegener.com
43
iPump6400 User’s Manual
From Date/Time Setup, adjust the current date, time, offset from GMT, and daylight saving time settings as follows:
800009-01 Rev. B
Step Press Displayed/Field Details
Screen
Type a)
ENTER
b) c) d)
CURRENT DATE
YYYY/MM/DD
Enter current date in year/month/day format.
CURRENT TIME
HH:MM:SS
Enter current time in hours:minutes:seconds format.
User Input
- Editable
User Input
- Editable
OFFSET FROM GMT
GMT -5 (EST/EDT)
Select the appropriate offset from Greenwich
Mean Time (GMT). Offset selections range from GMT -12 to GMT +11. (Eastern U.S. is at
GMT -5; West Coast U.S. is at GMT -8.)
DAYLIGHT SAVING TIME
OBSERVED? YES
Select Yes if daylight saving time is observed in your area or No if it is not.
User Input
-Selectable
User Input
-Selectable
44 wegener.com
