JVC DR-MV100B User Manual pdf

36

Timer Recording Troubleshooting

Even though the timer is set, the recorder will not record when:

• There is no disc (or tape) loaded.

• A non-recordable disc (or tape) is loaded.

• Disc Protect is set to [ON] in the Disc menu

(see page 21).

• There are already 99 titles (DVD-RW, DVD-R,

DVD-RAM), 49 titles (DVD+RW, DVD+R) recorded on the disc.

You cannot enter a timer program when:

• A recording is already underway.

• The time you’re trying to set has already passed.

• There are already 16 timer programs set.

If two or more timer programs overlap:

• The earlier program takes priority.

• When the earlier program finishes, the later program starts.

• If two programs are set to start at exactly the same time, the program entered first takes priority.

If the disc is damaged, the recording may not complete successfully. In this case even though the

Check field shows [Rec. OK], it may not be.

Note:

Recording programs that are blocked through

Parental Lock or TV Ratings will present the following message: "Cannot Record-No Input Signal". Please disable/ adjust the TV Rating (See page 19) or the

Parental Lock (See page 18) before recording the program when you want to record.