advertisement
Symptom
Picture or sound of broadcasting channel is weak or missing.
Can’t play disc recorded on this Recorder on another DVD player.
Cause
Antenna or cables are loose.
Wrong Tuning Band is selected in the
Recorder Setup menu.
The disc was recorded in Video mode.
Some players will not play even a finalized disc recorded in Video mode.
The disc was recorded in VR mode.
Cannot record or did not record successfully.
Stereo Audio Record and/or Playback not present.
Discs recorded with copy-once material cannot be played on other players.
The remaining blank space on the disc is insufficient.
The source you are trying to record is copy-protected.
When setting the recording channel, the channel is tuned on the TV’s own tuner.
When recording to a Video mode disc, programs that are copy-once protected cannot be recorded.
TV is not Stereo-compatible.
Broadcast program is not in stereo format.
Recorder A/V Out jacks are not connected to TV A/V In jacks.
Recorder Audio/Video Out is not selected for viewing at the TV.
Recorder’s TV audio channel is set to
SAP or MONO.
Correction
Tighten connections or replace cable.
Try [Auto Channel Set] options; see page 16 for details.
Finalize the disc; see page 21.
No solution.
The other player must be RW compatible in order to play it.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the Recorder’s built-in TV tuner.
Use a VR mode formatted disc for copy-once material.
No solution.
No solution.
Make A/V connections. Stereo is available only via A/V output from Recorder.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo using AUDIO button.
Resetting the Recorder
If you observe any of the following symptoms...
• When the Recorder is plugged in, but the power will not turn on or off.
• When the display window is not working.
• When the Recorder does not operate normally.
You can reset the Recorder as follows:
• Press and hold the STANDBY/ON button for more than five seconds. This will force the
Recorder to power off.
Press the STANDBY/ON button again to turn the Recorder back on.
• Unplug the power cord and then plug the power cord again after more than five seconds.
51
advertisement