advertisement
Rear Quarter Glass
GLASS/WINDOW/MIRROR
18.Rear Quarter Glass
A: REMOVAL
Remove the glass in the same procedure as for windshield glass. <Ref. to GW-25, REMOVAL, Windshield
A
A-A D-D
B
C
(3)
(1)
(2)
(4)
(3)
(4)
(2)
(1)
D
(5)
B-B
(2)
C-C
(6)
(3)
(3)
(2)
(1)
(8)
(7)
(5)
(5)
GW-00054
(1) Molding
(2) Adhesive
(3) Interior trim
(4) Locating pin
(5) Body
(6) Cover C pillar
B: INSTALLATION
1) Cut off the nozzle tip as shown in the figure.
(4)
(5)
(6)
(1)
(3)
(2)
(3)
(1) Molding
(2) Matching pin
(3) Adhesive
(4) 10 mm (0.39 in)
(5) 15 mm (0.59 in)
(6) 10 — 13 mm (0.39 — 0.51 in)
(1)
GW-00079
(7) Weather strip
(8) Rear door glass
2) Install the glass in the same procedure as for wind-
shield glass. <Ref. to GW-26, INSTALLATION,
3) After completion of all work, allow the vehicle to stand for about 24 hours.
NOTE:
• When the door is opened/closed after glass is bonded, always lower the door glass and then open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and time the vehicle must be left standing before driving after bonding, follow instructions or instruction manual from the adhesive manufacturer.
4) After curing of adhesive, pour water on external surface of vehicle to check that there are no water leaks.
GW-32
Rear Quarter Glass
NOTE:
When a vehicle is returned to the user, tell him or her that the vehicle should not be subjected to heavy impact for at least three days.
GLASS/WINDOW/MIRROR
GW-33
advertisement
Related manuals
advertisement